1) Spread air cushion
2) Open the gas nozzle to automatically inflate the air bed. Close the gas nozzle, fold the air bed back and forth, and then press it for a few times. Then open the valve and allow the air bed to expand automatically to fully restore its elasticity and shape.
2, inflatable method:
1) Open the air cushion, open the gas nozzle, and the air cushion bed will automatically begin to expand.
2) Wait until the air bed expansion is complete, then tighten the valve cover.
3) Adjust the air pressure and adjust its comfortable hardness.
Note: If you keep it in a rolled state for a long period of time (not recommended), inflate it with your mouth several times.
3, the exhaust method:
1) Open the gas nozzle, roll up from the other end of the gas nozzle, and press the air out.
2) Close the gas nozzle, wind the air bed from the other end, and open the gas nozzle again to discharge the remaining air.
3) Finally close the valve and it can be saved in a rolled state at any time.
Note: Please put it in the outsourcing bag when carrying, to avoid scratching.
4, custody method:
Spread the air cushion, open the air nozzle, store it in a cool and dry place (example: on the bottom of the bed or behind the sofa, etc.), because the sponge of the air bed has a memory shape and can quickly expand into the most commonly used shape.
5, repair methods:
1) Confirm the leak: Close the valve after inflation and inflate it with water or thin soapy water, fold it in half, press it with your knees and pressurize it with your body weight. The blistering area is where the air leaked. Make a mark.
2) Small hole repair: Dry the air-cushion bed completely, vent air, and add the adhesive on the hole. Because the air is exhausted, the adhesive is inhaled and seals the hole. Afterwards the adhesive hardens.
3) Repair the big damage: Dry the air bed completely and deflate the air. Apply glue on the repair cloth. Apply glue to the hole on the surface of the air bed. Let it dry for 30 seconds to 3 minutes (depending on the temperature). Place, flatten, keep for 4 hours before use.
6, clean:
Inflate the air bed to the maximum limit, close the valve tightly, use a soft brush and a low-stimulus household degreasing detergent or lotion, rinse thoroughly with water after washing in the bathtub, and store it completely dry.
7. Note:
1) Do not approach sharp objects (barbed plants or sharp stones or blades).
2) When not using the tent, please lay a cloth under the air bed.
3) Do not use it as a buoyancy aid.
4) Keep away from flames or sparks.
5) When the air temperature is high, do not place the air mattress that has inflated and closed the valve in the car or tent.
6) Do not touch sunscreen or alkaline medicines.
7) Do not expose to sunlight for a long time. Ultraviolet rays will slowly damage the surface material.
8) Please place it in a place that cannot be touched by pets.
9) The gas nozzle part is hard and should be avoided during rest.
Embroidery Badge,Embroidery Logo,Animal Cute Embroidery Badges
Shirt Interlining CO.,LTD , http://www.nsshirtinterlining.com