With the continuous development of cleaning technology, high pressure water rinsing has been used in bogie and wheelset cleaning. Because high-pressure water washing can save water, no cleaning agent, low cost, good washing quality, and reduce environmental pollution, it should be gradually promoted. The plunger valve of the diesel fuel injection pump and the needle valve of the injector are one of the high-precision parts. They are very sensitive to dust and require high cleaning quality. Therefore, its cleanliness is the highest, so high quality must be used. The cleaning equipment is an ultrasonic cleaner to achieve high quality cleaning results. The carbon deposit of the turbocharger worm blade is difficult to clean due to the silicate. After a variety of cleaning agents and a variety of cleaning equipment, the effect of cleaning the worm blade is not satisfactory, and the silicate part can not be eliminated. For this purpose, according to the tooling equipment required for overhaul of the supercharger, a horizontal grinding machine is used to remove the carbon deposits from the blades. The inner chamber of parts with oil and water pipes, such as coolers, heat exchangers, preheating boilers, etc., adopts cyclic reverse flushing.
In order to improve the cleaning quality, the parts should be cleaned with a high-vacuum dust collector or pre-cleaned with clean water before cleaning, and can reduce the pollution degree of the cleaning liquid and prolong the service life of the cleaning liquid. Parts requiring high cleanliness, such as cylinder heads, can be rough-washed. For parts that adhere to heavy oils and greases, such as bearings, a water-washing process can be used to prevent rusting of parts. After washing or rinsing, parts should be washed out with soft high-pressure water washing machine to remove loose dirt and rinse dead angles. Use clean water to flush out the cleaning liquid attached to the parts to avoid corrosion of parts. After the cleaning, apply compressed air or clean cotton yarn to remove the water from the parts to prevent charcoal. The electrical components can be dried. In short, the cleaning process should be based on the requirements of the cleaning operation, and the local conditions should be formulated.
Imported French lens
Mould Die-casting Eight edge type Revolving arm
Each LED can be replaced individually, which guarantees maximum economy.
Configuring lightweight balance arm suspension system ,six groups universal joint linkage ,mobile, lightweight positioning and stablibity .A 360°all-round design ,can meet the need for surgery in different heights and angles.
Color temperature constant, soft, very close to the natural sun light.
The use of liquid crystal display button control, to meet the needs of the medical staff of different patients with the brightness of the operation.
Flower Type Operating Light,Operating Room Lights,Petal Led Surgical Lights,Petal Type Led Surgical Lights
Shandong qufu healthyou Medical Technology co.,Ltd , https://www.kangerjianmedical.com