Brief introduction of the precautions for the use of ultraviolet aging test box
Shanghai Jianhu Instrument Equipment Co., Ltd. is a high-tech joint venture enterprise, specializing in the design, development, production, sales, and service reliability of environmental experiment equipment. Its main products are high and low temperature and humidity chambers, programmable constant temperature and humidity chambers, and it has entered the environmental laboratory- , WALKING-IN, salt spray box, constant temperature and humidity machine, hot and cold impact machine, vibration constant temperature and humidity compound testing machine, etc. Experienced and trusted and supported by many domestic and foreign manufacturers. The factory is set up in Shanghai, the network radiates to China, and customers are all over the world.
The UV aging test box is suitable for the aging test of non-metallic materials against sunlight and artificial light sources. For safer use, pay attention to the following points:
1. After stopping use for a long time, if you need to use it again, you must carefully check the water source, power supply and various parts, and then start the equipment after confirming that it is correct.
2. The test stage should minimize the time to open the door.
3. The sensor device in the working room must not be subjected to strong impact.
4. During the operation of the equipment, sufficient water source must be maintained.
5. Non-full-time operators shall not operate at will.
6. Please contact our company when the equipment appears to be unable to troubleshoot itself.
7. Because ultraviolet radiation has a strong hazard to people (especially eyes), operators should minimize exposure to ultraviolet rays (contact time should be <1min). It is recommended that the operator wear protective goggles and a protective cover.
Maintenance of ultraviolet aging test box:
In order to make the equipment work better and maintain a good condition for a long time, it should be regularly maintained and maintained:
1. When the equipment is not in working condition, it should be kept dry, drain the water after operation, and dry the studio and cabinet.
2. After use, cover the plastic cover to avoid dust intrusion. If there is dust, it should be removed.
Powder Packaging Bags,Putty Powder Packaging Bag,Putty Powder Chemical Bags,PP Putty Powder Packaging Bag
ZHEJIANG IMERIC ENVIRONMENTAL PROTECTION SCIENCE & TECHNOLOGY CO., LTD. , https://www.imeric-valvebags.com