Human adrenocorticotropic hormone ELISA detection kit This reagent is for research use only Specimen: Serum or plasma Test principle: ACTH kit is a solid-phase sandwich enzyme-linked immunosorbent assay (ELISA). Standards with known ACTH concentration, unknown concentration The samples were added to the microplate for detection. Incubate ACTH and biotin-labeled antibodies first. After washing, HRP labeled with avidin was added. After incubation and washing, the unbound enzyme conjugate is removed, and then substrates A and B are added to act simultaneously with the enzyme conjugate. Produce colors. The color depth is proportional to the concentration of ACTH in the sample. Safety Avoid direct contact with the stop solution and substrates A and B. Once exposed to these liquids, rinse with water as soon as possible. Do not eat, drink, smoke or use cosmetics during the experiment. Do not use your mouth to absorb any ingredients in the kit. Handling precautions Reagents should be stored according to label instructions, and returned to room temperature before use. The sparse standards should be discarded and cannot be stored. The slats not used in the experiment should be immediately returned to the packaging bag, sealed and stored to avoid deterioration. Unused other reagents should be packed or covered. Do not mix reagents of different batches. Use before warranty. Use a disposable pipette tip to avoid cross-contamination, and avoid using a sampler with a metal part when drawing the stop solution and substrates A and B. Use a clean plastic container to prepare the washing solution. Mix all components and samples in the kit thoroughly before use. When washing the enzyme-labeled plate, it should be fully patted dry. Substrate A should evaporate to avoid opening the lid for a long time. Substrate B is sensitive to light and avoid prolonged exposure to light. Avoid contact with hands, it is toxic. The OD value should be read immediately after the experiment is completed. The order of adding reagents should be the same to ensure that all wells are incubated for the same time. Perform the incubation operation according to the time, the amount and order of the liquid indicated in the instructions. Sample collection, processing and storage methods Serum-avoid any cell stimulation during the operation. Use test tubes free of pyrogens and endotoxins. After collecting blood, centrifuge at 1000 × g for 10 minutes to separate the serum and red blood cells quickly and carefully. Plasma ----- EDTA, citrate, heparin plasma can be used for detection. Centrifuge at 1000 × g for 30 minutes to remove particles. The cell supernatant was centrifuged at 1000 × g for 10 minutes to remove particles and polymers. Tissue homogenate ----- Mash the tissue with appropriate amount of saline. Centrifuge at 1000 × g for 10 minutes, and take the supernatant for storage. If the sample is not used immediately, it should be divided into small parts and stored at -70 ℃ to avoid repeated freezing. If possible, do not use hemolysis or hyperlipidemia. If there are a large number of particles in the serum, centrifuge or filter before testing. Do not thaw at 37 ° C or higher. Thaw at room temperature and ensure that the sample is thawed evenly and adequately. Before use, mix all reagents thoroughly. Don't make the liquid generate a lot of foam, so as to avoid adding a large number of bubbles during sample addition, which will cause errors in sample addition. The number of slats required is determined by the number of samples to be tested plus the number of standard products. It is recommended to make multiple holes for each standard and blank hole. Each sample is determined according to its own quantity, and those that can use multiple holes can be used as much as possible. The specimen was diluted 1: 1 with the specimen dilution solution and then added 50ul to the reaction well. Add 50ul of the diluted standard to the reaction well and 50ul of the sample to be tested in the reaction well. Immediately add 50ul of biotin-labeled antibody. Cover the membrane plate, gently shake and mix, and incubate at 37 ° C for 1 hour. Shake off the liquid in the wells, fill each well with washing liquid, shake for 30 seconds, shake off the washing liquid, pat dry with absorbent paper. Repeat this operation 3 times. If washing with a plate washer, the number of washes is increased once. Add 80 ul of streptavidin-HRP to each well, gently shake and mix, and incubate at 37 ° C for 30 minutes. Shake off the liquid in the wells, fill each well with washing liquid, shake for 30 seconds, shake off the washing liquid, pat dry with absorbent paper. Repeat this operation 3 times. If washing with a plate washer, the number of washes is increased once. Add 50ul of substrate A and B to each well, mix gently by shaking, and incubate at 37 ° C for 10 minutes. Avoid light. Remove the enzyme labeling plate and quickly add 50ul of stop solution. After adding the stop solution, the results should be measured immediately. The OD value of each well was measured at a wavelength of 450 nm. The results of standard No. 6 and above are non-linear, and accurate results cannot be obtained based on this standard curve. Kit performance 1. Sensitivity: The minimum detection concentration is less than No. 1 standard. Linearity of dilution. The correlation coefficient between the linear regression of the sample and the expected concentration is 0.990. 2. Specificity: Does not react with other cytokines. 3. Repeatability: The coefficients of variation within and between plates are less than 10%. Judgment and analysis of results 1. Instrument value: read the OD value of each well on a microplate reader with a wavelength of 450 nm. 2. Take the absorbance OD value as the ordinate (Y), and the corresponding ACTH standard concentration as the abscissa (X) To make the corresponding curve, the ACTH content of the sample can be converted from the standard curve to the corresponding concentration according to its OD value. 3. Detection range: 0-800 pg / ml 4. Sensitivity: 1.0 pg / ml MGMT (O6-methylguanine-DNA methyltransferase) O6 methylguanine DNA methyltransferase antibody 0.1 ml MGMT (O6-methylguanine-DNA methyltransferase) O6 A Guanine DNA methyltransferase antibody 0.2mlMT (metallothionein) metallothionein antibody 0.2mlMGr1-Ag / 37LRP (P37-kDa laminin receptor precursor) (NT) laminin receptor 1 antibody (N-terminal) 0.2mlMTA1 (Metastasis -associated 1) Tumor metastasis associated protein 1 antibody 0.2mlMGr1-Ag / 37LRP (P37-kDa laminin receptor precursor) (CT) laminin receptor 1 antibody (C-terminal) 0.2ml Myf6 (Myogenic factor 6) myogenic regulator 6 Antibody 0.2mlGuinea IgM / APC Fluorescein APC-labeled Guinea Pig IgM 0.1ml Horse IgG / APC Fluorescein APC-labeled Horse IgM / APC Fluorescein APC-labeled Horse IgM 0.1mlhuman IgG / APC Fluorescein APC-labeled Human IgG 0.1mlhuman IgM / APC Fluorescein APC labeled human IgM 0.1ml MICA (MHC class I polypeptide-related sequence A) Cell stress molecule antibody 0.2ml Microsporidia bee microsporidia protein antibody 0.2ml Midnolin isoform Protein 1 in Brain nucleolar protein 1 antibody 0.2ml
The Malachite mineral is attractive to look at... with its swirling patterns and varying colors of green. This is the most common form you will find it in, but it may also be found as needle-like crystals and prismatic crystals.
It is often found inter-growing with other minerals... in particular the Azurite Malachite mixture is quite common, but it may also be found with a number of other copper based minerals, including Eilat Stone, Turquoise and Chrysocolla.
Its name dates back to ancient times and it is said that it originated from the Greek word for mallow 'malache', because of its color. It was used to make jewelry and ornaments as far back as 3000 BC, when it was in use in ancient Egypt.
Many of the ancient people also used it to make talismans as they believed it to be highly protective... which it is! Its vibration attracts people even though they are often not sure why... and it is one of the most popular stones sold for metaphysical purposes.
Malachite
Natural Malachite Gemstone Jewelry & Jewellery-Beads,Anklet,Bracelet,Earrings,Necklace,Pendant,Rings,Jewellery
JOYA GIFT CO.,LIMITED , http://www.joyagifts.com